Installation Guide
Luxello illuminated house numbers use 8–12V AC or DC low voltage — safe to handle and straightforward to install. A qualified electrician is only needed for the mains connection, or bypass mains entirely with a solar system.
Luxello illuminated house numbers operate on 8–12V AC or DC low voltage — not mains voltage. This makes the installation safe to handle and suitable for competent DIY on the low voltage side. The only step that requires a qualified electrician is connecting the LED driver to the 230V mains supply.
UK electrical note: The LED driver connection to 230V mains should be made by a qualified electrician. Alternatively, connect to a 12V solar system — no mains connection required at all. See our solar guide for details.
Hold the number against the wall at the desired position. Mark the mounting hole locations with a pencil. Use a spirit level to ensure the number sits straight. For multiple digits, use card cut to the width of one number to keep spacing consistent.
Drill mounting holes using a masonry bit for brick or render, or a wood bit for timber cladding. Drill a separate hole for the cable entry, positioned so it will be concealed behind the number once mounted. Feed the 12V cable through from inside the wall or from the surface.
Insert rawlplugs into masonry holes. Pass the low voltage cable through the rear of the number. Fix to the wall with the supplied screws. Apply a small bead of clear silicone sealant around the cable entry point to prevent moisture ingress.
Connect the 12V cable from the number to the output terminals of the LED driver. Luxello numbers have no polarity — the wires are interchangeable. A single power supply can illuminate up to 6 numbers. House the driver in a weatherproof enclosure if installed externally.
Connect the driver's 230V mains input to a fused spur or outdoor socket — this step requires a qualified electrician. Alternatively, connect directly to a 12V solar power system, bypassing mains entirely. A dusk-to-dawn photocell can be installed on the switch to automate night-time illumination.
Switch on and confirm the number illuminates evenly. Luxello numbers use concealed LED strips which produce a consistent, even halo-glow across the full face. If illumination is uneven, check all 12V cable connections.
Luxello numbers run on 8–12V AC or DC. A single power supply can illuminate up to 6 numbers — connect the wires from each number to the same power supply. There is no polarity, so the wires are interchangeable.
| Power option | Electrician required? | Notes |
|---|---|---|
| Mains via LED driver | Yes — for mains connection | Most reliable, unlimited run time |
| 12V solar system | No | Panel + charge controller + battery — see solar guide |
| Battery power pack | No | Must output 8–12V AC or DC — suitable for temporary installations |
| Doorbell transformer | No (if existing) | Many existing doorbell transformers output 12V AC — compatible |
A dusk-to-dawn light sensor (such as a Lutron photocell switch) can be installed on the power supply to turn the numbers on automatically at night and off at dawn — reducing energy consumption and extending LED lifespan. Luxello also guarantees replacement LED panels are available for 10 years from purchase — so if a panel ever needs replacing, it can be.
